The Challenges to Swim Spa Covers

Swim Spas represent distinct challenges when it concerns covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same reasons a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, removing and changing the cover can be a lot more difficult.
Getting a new swim spa is an exciting event in life. You’re eagerly anticipating the workout you’ll obtain from using it. Maybe you’re a little relieved to have finally made a selection from the various models you looked at. At any rate, you probably weren’t believing much about the cover you would use.
Normally, the cover that gets back with your brand-new purchase will be a four area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Until it begins to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style defect. Built in obsolescence because as soon as it is positioned in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper will not make any difference. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are extremely small as they increase from the water surface. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It occurs slowly and on a Swim Spa Cover which is made from specific areas, at varying speeds. So ultimately you’ll see one or two of the sections are really getting heavy. The bar lifters on completions of the swim spa aren’t much help because you still need to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com came up with a different style for their Swim Spa Covers
Instead of using a number of foam panels to develop Swim Spa Covers that will ultimately wind up in some landfill, they created one that uses air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or fall apart at the joints either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the cover for it.
If you’re not all set to buy today, bookmark this site so you can discover it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *