The Challenges to Swim Spa Covers

Swim Spas represent unique challenges when it concerns covering them.
We can all agree that the swim spa has to be covered when not in use for all the same reasons a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, removing and replacing the cover can be a lot more difficult.
Getting a brand-new swim spa is an interesting event in life. You’re anticipating the exercise you’ll get from using it. Maybe you’re a little relieved to have lastly made a selection from the various models you looked at. At any rate, you probably weren’t thinking much about the cover you would use.
Usually, the cover that gets home with your new purchase will be a four section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style defect. Integrated in obsolescence due to the fact that as quickly as it is put in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any difference. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are really small as they rise from the water surface area. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.

It occurs gradually and on a Swim Spa Cover which is made of individual sections, at differing speeds. So ultimately you’ll see a couple of of the sections are really getting heavy. The bar lifters on completions of the swim spa aren’t much assistance because you still have to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a new style for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will eventually wind up in some landfill, they designed one that uses air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or fall apart at the seams either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to purchase today, bookmark this website so you can discover it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *