The Challenges to Swim Spa Covers

Swim Spas represent distinct obstacles when it comes to covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same factors a hot tub needs a cover. The challenge is that because of the length of the swim spa and the height of the sides, removing and replacing the cover can be a lot more difficult.
Getting a brand-new swim spa is an amazing occasion in life. You’re anticipating the workout you’ll get from using it. Perhaps you’re a little relieved to have actually finally made a selection from the various designs you took a look at. At any rate, you probably weren’t thinking much about the cover you would use.
Typically, the cover that comes home with your brand-new purchase will be a four area stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design defect. Integrated in obsolescence since as soon as it is placed in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper will not make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are very small as they increase from the water surface area. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It takes place gradually and on a Swim Spa Cover which is made from specific areas, at differing speeds. So ultimately you’ll discover one or two of the sections are really getting heavy. The bar lifters on completions of the swim spa aren’t much help since you still have to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a new design for their Swim Spa Covers
Instead of using several foam panels to build Swim Spa Covers that will ultimately wind up in some garbage dump, they created one that utilizes air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate much better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers won’t fade, or break down at the joints either. So if you own a swim spa, and you intend to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to purchase today, bookmark this site so you can discover it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *