The Challenges to Swim Spa Covers

Swim Spas represent distinct challenges when it comes to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same factors a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot harder.
Getting a new swim spa is an interesting occasion in life. You’re anticipating the workout you’ll get from using it. Perhaps you’re a little relieved to have actually lastly made a selection from the various designs you looked at. At any rate, you most likely weren’t thinking much about the cover you would use.
Typically, the cover that comes home with your brand-new purchase will be a four area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style flaw. Built in obsolescence due to the fact that as soon as it is positioned in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper won’t make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are very small as they increase from the water surface. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.
It takes place gradually and on a Swim Spa Cover which is made from specific sections, at differing speeds. So ultimately you’ll notice a couple of of the areas are actually getting heavy. The bar lifters on completions of the swim spa aren’t much help because you still need to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com developed a different design for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will eventually wind up in some landfill, they created one that utilizes air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or break down at the seams either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not prepared to purchase today, bookmark this website so you can discover it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *