Getting The Best Swim Spa Cover

Swim Spas represent special challenges when it comes to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same reasons a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot harder.
Getting a brand-new swim spa is an interesting event in life. You’re looking forward to the exercise you’ll obtain from using it. Perhaps you’re a little relieved to have actually finally selected from the different models you took a look at. At any rate, you most likely weren’t thinking much about the cover you would use.
Generally, the cover that gets home with your new purchase will be a four section stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design defect. Integrated in obsolescence since as soon as it is positioned in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any difference. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are extremely small as they increase from the water surface. They make their way into the little fractures and crevices in the foam.

Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It happens slowly and on a Swim Spa Cover which is made of specific areas, at varying speeds. So ultimately you’ll discover a couple of of the areas are really getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance because you still have to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a different design for their Swim Spa Covers
Instead of using several foam panels to construct Swim Spa Covers that will eventually wind up in some land fill, they designed one that utilizes air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or fall apart at the seams either. So if you own a swim spa, and you intend to keep using it everyday, SpaCap.com has the cover for it.
If you’re not prepared to purchase today, bookmark this website so you can discover it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *