Getting The Best Swim Spa Cover

Swim Spas represent distinct challenges when it concerns covering them.
We can all agree that the swim spa has to be covered when not in use for all the same reasons a hot tub requires a cover. The obstacle is that because of the length of the swim spa and the height of the sides, removing and changing the cover can be a lot more difficult.
Getting a new swim spa is an exciting occasion in life. You’re looking forward to the exercise you’ll get from using it. Perhaps you’re a little relieved to have finally made a selection from the various designs you looked at. At any rate, you most likely weren’t believing much about the cover you would use.
Normally, the cover that comes home with your new purchase will be a 4 area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it begins to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style flaw. Built in obsolescence since as quickly as it is positioned in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper won’t make any difference. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are extremely little as they increase from the water surface. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.
It takes place gradually and on a Swim Spa Cover which is made of private areas, at varying speeds. So eventually you’ll notice a couple of of the sections are truly getting heavy. The bar lifters on the ends of the swim spa aren’t much aid due to the fact that you still have to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com came up with a different design for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will ultimately end up in some landfill, they created one that utilizes air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers won’t fade, or fall apart at the joints either. So if you own a swim spa, and you plan to keep using it everyday, SpaCap.com has the cover for it.
If you’re not prepared to order today, bookmark this website so you can discover it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *